All Weather Acrylic
Acrylic Sissons All Weather Paint is an extremely durable water-based coating for the protection and decoration of all exterior masonry surfaces. Upon proper and correct application methods and conditions, this product is extremely resistant to fungal / algae growth, alkaline / efflorescence attack and harsh tropical weather conditions. Its special acrylic binder also ensures excellent adhesion of the paint to the substrate.
Surface
Adequate surface preparation should be carried out before application. All loose, flaking, chalking or friable materials should be removed. Make good any defects and ensure that the substrate is clean and free from contaminants, such as oil, grease, grime and fungal growth.
For new surfaces, ensure that the substrate is sufficiently dry (below 16% moisture) prior to paint application.
For redecoration, ensure that the previous coating is in good condition, otherwise remove via water-jet and/or scraping then treat as per new surface.
New Surface
| Primer | 1 coat of Sissons Alkali Resisting D’Primer or Sissons All Weather Sealer |
| Finish | 2 coats of Sissons All Weather Acrylic Paint |
Redecoration
| Primer | 1 coat of Sissons Alkali Resisting D’Primer or Sissons All Weather Sealer |
| Finish | 2 coats of Sissons All Weather Acrylic Paint |
Problematic Surface
| Primer | 1- 2 coats of Sissons Powerkote Primer (Solvent-Based) |
| Finish | 2 coats of Sissons All Weather Acrylic Paint |
If the substrate colour is uneven, or in the case of re-decoration there is a radical change in colour, an additional coat of finishing may be required.
Coverage
| Theoretical Coverage | 11.5 square meters per litre per coat |
|
Expected Practical Coverage Based on 25% Loss Factor |
8.6 square meters per litre per coat |
Actual spreading rate will vary due to factors such as method and condition of application e.g. surface profile or roughness.
Application Techniques
Brush, Roller, Airless Spray
Thinning
| Brush / Roller | Ready for use as supplied. However, a dilution of 5 -10% water by volume is allowed when necessary to assist application |
| Airless Spray | Ready for use as supplied |
Drying Time
| Touch Dry | ¾ hour |
| Hard Dry | 1½ hours |
| Recoating Time | After 2 hours |
Cleaning Up
Clean all equipment with clean water immediately after use.
